Calmag 15mm In-line Magnetic Scale Inhibitor SI-CALMAG-15
The CalMag magnetic scale inhibitor is suitable for installation on cold water lines for preventing the formation of limescale. The unit comes complete with 2 x 15mm compression fittings.
Benefits
- Lifetime guarantee
- No maintenance
- No chemicals
- Whole house protection
- Protects boiler
Specifications
- Overall length: 190mm excluding fittings
- Diameter: 15mm
- Material: Chrome Plated copper
- Fittings: 15mm to 15mm compression (STD)
- Maximum working pressure: 12 bar (168 psi)
- Maximum temperature: 80 deg C
- Maximum flow rate: 1.08 l/sec (14gpm)
Installation
- Turn off the water supply.
- Drain relevant pipework or system where the CalMag-15 unit is to be installed.
- Allow time for the system to cool down if fitted in line.
- Cut pipework to suit length of unit. For best results install at least 1 metre away from an appliance.
- Push the unit into place, ensuring that the fittings are pushed fully into position.
- Tighten the compression fittings to make a seal.
- Re-open the system slowly.
- Check for leaks.
|
